Curtis Computer Network Router VoomPC 2 User Manual

VoomPC-2™ Automotive PC Enclosure  
Mini-ITX Car PC Enclosure  
Installation Guide  
Version 1.0  
P/N VOOM-PC-2-ENC  
Before you start…  
 
http://www.cartft.com, Cool Embedded PCs  
1.0 Introduction  
Thank you for purchasing the VoomPC-2 mini-ITX vehicle enclosure!  
The VoomPC-2 was designed to work with a wide variety of main boards such as the VIA  
mini-ITX boards as well as low power Pentium-M OR Core 2 Duo. Please note that  
powering full power P4 or AMD systems is not recommended due to excessive heat  
dissipation.  
2.0 Required tools  
+
Reverse and  
forward protection  
+
-
Switch Logic  
6-30V ATX PSU  
PC ATX  
power  
MotherBoard  
Battery  
GND  
ON/OFF switch  
J6  
SW  
J2  
Ignition  
8bit MCU  
Optional On/OFF switch  
LED  
J8  
Amplifier  
Enable  
M1-ATX  
J4  
In order to install the VoomPC-2 in your vehicle you will need the following:  
-Phillips screwdriver and Wire cutter / stripper  
-Few feet of wire (AWG 12-16), preferably color coded, used for power input.  
VoomPC-2 Installation Guide  
Page 3  
 
http://www.cartft.com, Cool Embedded PCs  
Figure 1.0, bottom mounting plate  
3.0 VoomPC-2 installation steps  
1) Install the motherboard, Front Audio / USB board and Power Supply on the base plate  
using M3 screws. (See figure 1.0)  
2) Connect the ATX cable harness provided with your power supply to the motherboard.  
NOTE: Use small tie-wraps on the ATX cable harness in order to improve air flow.  
3) Connect the Front Audio header (marked “AUDIO”) to the motherboard’s Front Audio  
header using the 2x5 shielded cable. NOTE: You need to remove the 2 jumpers from the  
Motherboard’s Front Audio header.  
4) Connect the Front USB header (marked “USB”) to the motherboard’s internal USB  
header.  
5) Connect the LED header to the Motherboard’s LED header. If using M1-ATX or M2-  
ATX power supplies you might want to connect this LED to the power supply LED  
header. (The M1/M2-ATX provides additional visual information (blinks) reporting various  
states of the system)  
6) Connect the Fan-In header to the motherboard’s fan header. Connect the Fan1 and  
Fan2 headers to the front fans.  
VoomPC-2 Installation Guide  
Page 4  
 
http://www.cartft.com, Cool Embedded PCs  
7) Install the HDD and CDROM (optional) into the metal bracket and connect to the  
motherboard using the IDE cable.  
8) Install the motherboard I/O shield at the back of the VoomPC-2 enclosures  
Figure 1.1, bottom mounting plate  
9) Your final assembly should look similar to Figure 1.1. Slide the bottom plate into the  
extrusion and stop half way into the slide. Connect the power input faston wires to the  
Power Supply unit. (In case you are using a Power Amplifier, connect the AMP RMT  
wires to the Power Supply Anti-Thump header.  
10) Hook up Monitor, Keyboard, etc and test your system by turning ignition ON.  
11) Secure the VoomPC-2 using the 4 front/back mounting screws. If you don’t want to  
drill holes into your car chassis, stick large Velcro pads to the bottom plate of the  
VoomPC-2 (the hook side) and attach to your car’s carpet and a strong adhesion will be  
formed.  
VoomPC-2 Installation Guide  
Page 5  
 
http://www.cartft.com, Cool Embedded PCs  
4.0 Power Connector Wiring Diagram  
Figure 1.3, power connector diagram  
Connector type is Molex “mini-fit JR” series, 2 x 4 configuration. Consult www.molex.com  
for additional information on housings and mating pins (male/female). All “mini-fit JR”  
NOTE: The Black and Green wire harness labeled “not connected” is intended to special  
projects use. For example, should you need additional 5V or 12V output, you could take  
advantage of this pre-installed wires.  
5.0 Mechanical  
-Dimensions: 210(W)x265(L)x66(H)mm  
-Weight, including packaging: 3.0Kg  
6.0 Support and warranty  
Standard Hardware Warranty 1Year / US, 2 Year EU  
Installation support: 30days via email, support@cartft.com.  
Additional accessories can be purchased on-line from www.cartft.com.  
VoomPC-2 Installation Guide  
Page 6  
 

Cornelius Beverage Dispenser JT30 User Manual
Creda Oven E420E User Manual
Dacor Cooktop ETT304 1 User Manual
Eaton Electrical Double Oven ESWA0800SC User Manual
EdgeStar Beverage Dispenser KC2000SSTWIN User Manual
Electro Voice Speaker EVX 180B User Manual
Frigidaire Washer FWT449GF User Manual
Fujitsu All in One Printer FP 410 User Manual
Gefen Network Router EXT DVI 444DL User Manual
GE Vacuum Cleaner 106687 User Manual