ZHU30RSM
GE Monogram® 30" Electric Induction Cooktop
Dimensions and Installation Information (in inches)
A
B
16" Min
2" Min.
to Side Walls
1-3/4"
Min.
Junction
Box
C
D
2-1/2"
Min.
to Front
Edge
Cutout Dimensions:
30" Models
A
B
C
D
3-1/4"
ZHU30RSM 29-7/8" 21-1/2" 28-1/2" 19-5/8"
6-1/4"
Electrical requirements
Product rating is 120/240V, 60Hz, 36" cooktops
to a 50-amp circuit; and 30" cooktops to a 40-
amp circuit. The cooktops must be connected
to a supply circuit of the proper voltage and
frequency and protected by a time-delay fuse or
circuit breaker.
5-1/2"
Combination installations
Consideration must be given to electrical supply locations
when the cooktop is installed with other products in the same
cabinet. Always refer to each product's installation instructions
for clearances and electrical requirements.
All models require 12" minimum clearance below
the cooktop bottom to combustible materials.
• Install these cooktops with any exhaust hood of the same
or treater width; 300 CFM or greater air flow rating is
recommended.
• The 30" cooktop may be installed in combination with a
Monogram® 30" downdraft vent. Install the 36" cooktop with
a 36" downdraft vent. See downdraft vents for details.
• A Monogram single oven may be installed below these
cooktops.
The serial plate is located on the bottom of the cooktops.
For answers to your Monogram,® GE Profile™ or
GE® appliance questions, visit our website at
ge.com or call GE Answer Center® service,
800.626.2000.
Listed by
Underwriters
Laboratories
Specification Created 6/07
130254
|