Gianni Industries Door DG 1000M User Manual

DG-1000M

Stand alone Access Controller

35.5

127.5

Unit: mm

Convenient record listing of the user

card and password thru the connection

to the PC with USB.

Features

Allows up to 1000 proximity cards and PIN codes

Tamper switch and alarm buzzer included

Fully Programmable via keypad and master code

Access mode selectable:

card only ；card or PIN ；card+PIN

Logical memory to prevent duplication

Invalid PIN Lock-out

Beeper sound gives of keypad composition

Non-Volatile Memory

Removable memory chip replacement

Mifare High Frequency 13.56MHz

Stand-Alone Proximity Reader with USB Connector

Software Free of Charge

Overview

The DG-1000M offers one version request command and two

memory exchange commands. These memory commands,

used with knowledge of the EEPROM layout, allow almost

complete control over configuration, holder and transaction

memory. The exception to memory access is the

automatically-maintained memory contained within address

0x7000 and0x8000. This area contains checksums,

configuration backups and integrity markers to ensure the

validity of data on the unit.

GIANNI INDUSTRIES, INC.

No.306-1, Hsin Shu Road, Hsin Chuang, Taipei,Taiwan 242

TEL: 886-2-2206 9929

E-Mail: info@gianni.com.tw

Website: gianni.tw

The products are manufactured under an ISO

9001 QC 080000 Certified Quality

Management Program environment back its

product quality, performance and commitment

to customer satisfaction.

FAX: 886-2-2204 6632

GP001

DM-CA-DG-1000M Ver. C Published on 2008.05.05