Edelbrock Automobile Parts 8824 User Manual

VICTOR SERIES ALUMINUM WATER PUMP  
For 1958-1979 361-440 (Incl. 426 Hemi) and 1969-1985 318-360 Chrysler V8s  
Part #8814, 8824, 8877 & 8887  
®
INSTALLATION INSTRUCTIONS  
PLEASE study these instructions carefully before beginning this installation. Most installations can be accomplished with common  
tools and procedures. However, you should be familiar with and comfortable working on your vehicle. If you do not feel comfortable  
performing this installation, it is recommended to have the installation completed by a qualified mechanic. If you have any questions,  
please call our Technical Hotline at: 1-800-416-8628, 7:00 am - 5:00 pm, Pacific Standard Time, Monday through Friday.  
IMPORTANT NOTE: Proper installation is the responsibility of the installer. Improper installation may result in poor  
performance and engine or vehicle damage.  
DESCRIPTION: The Victor series are heavy duty water pumps for both street and racing applications. These pumps are a direct  
replacement for the original equipment pump to provide compatibility with all accessories and pulleys. It offers weight savings along  
with increased durability and cooling potential. It is a standard rotation water pump for Chrysler Wedge (B & RB), 426 Hemi and Small  
Block engines and should not be used on engines converted to a serpentine belt pulley system.  
INSTALLATION: Installation is the same as for orignal equipment water pumps. Consult service manual for specific procedures.  
CAUTION: Be sure that the fan bolts don’t protrude through the hub so far that they hit the water pump housing. Check closely  
for any interference with drive belts; some filing for clearance may be necessary with some applications. Verify that the radiator  
fan is properly balanced. Imbalanced fans can cause severe damage and/or injury and will void your warranty.  
WARNING  
Incorrect alignment or an unbalanced condition puts excessive strain on the pump's shaft and/or bearing and will result  
in early failure of the shaft and/or bearing. The balance of the assembly depends primarily upon the concentricity of  
the fan clutch with the pump shaft. Concentricity is not assured when universal type clutches are used. The universal  
fan clutch has a 3/4" pilot hole, so an adapter must be used when installing a water pump with a 5/8" shaft. This  
adapter bushing is supplied with the unit. These adapter bushings add to the machine tolerances of the assembly, so  
special care must be taken to maintain concentricity with the shaft and the clutch fan.  
Edelbrock Corporation • 2700 California St. • Torrance, CA 90503  
Tech Line: 800-416-8628  
Part #8814, #8824, #8877 & #8887  
Rev. 5/09- AJ/mc  
©2009 Edelbrock Corporation  
Brochure #63-8814  
 

Cortelco Telephone 2194V0E27S User Manual
Curtis Clock Radio D 1855 User Manual
Cypress Computer Hardware STK14C88 3 User Manual
Dimplex Electric Heater OFRC20TI User Manual
Dodge Air Conditioner SP600 Series User Manual
Dynex Flat Panel Television DX LCD22 09 User Manual
Electro Voice Speaker EVI 12 User Manual
Gardena Water Pump WP1200 User Manual
Garmin Fish Finder 160 BLUE User Manual
Gefen Switch 2x1 DVI KVM Switcher User Manual